Dragstart Swiing - Ciao

Assembly: 1. Starter drive: Clean the mounting surfaces, then screw the counterpart of the cable starter onto the clutch or Variomat (secure the supplied flange nut with Loctite). 2. Pull starter: Simply attach the housing adapter using the motor screws. The round housing with the pull starter unit is then placed on top and secured with the supplied M5 x 45 mm screws. Finally, tighten the motor screws. Starting process: 1. Before starting, slowly pull the rope a few times so that the motor cranks over empty (must be done before each start attempt). 2. Pull out the pull start handle until it snaps and meets resistance. Then pull through in one sweep. Warning: When the pull starter is installed, the pedals become inaccessible (the pedal arms are on the pull starter housing). Therefore, footrests, a longer pedal shaft or a pedal shaft extension are required. Only drives are available on part number 32186